How to put a tightbore barrel in????

Ok i need help on how to do this do u like just screw it or what???a video would be the best but an expanation will do...

It helps some to know what AEG you have, so we can give better detailed instructions.

Well I can't give an accurate answer till we know.

Maybe he wants a G36 but has a M4?

Yes i do have an g36c im sorry i have been gone from the computer, so i couldnt not see replies....

hey sorry to revive an old thread but i have the same question: how do i install a tight bore in my JG G36C?

I am not sure but this vid might help you.

http://www.mechbox.com/site/upgrades/g36-upgrades/g36c-disassembly-video.html

You might have seen it before.

So, birchenboy, i know how to install tightbores in an M4, but I've never even used a G36, but I'll try to help. Hopefully the M4 is similar to your G36.
Anyway, once you have the top half of your G36 taken off (you can follow the video roboFURY listed) you might be able to just slide the inner barrel out. My M4 barrel is attached to the hop up assembly, which slides out with it. Then, you will be able to pull the barrel out of the hopup, and swap barrels. (it is possible that you will have to pull a small C shaped black plastic part off the hop up to release the barrel.) some guns also have small screws which hold the barrel in place.

thats sounds right i took the gear box out the other day and i think i could do that now

now i just need a new barrel since my friend forgot to order me one>

Here, this should help, I think ASR (airsoftretreat.com---go to their guides section) has a guide too.

http://pageproducer.arczip.com/daedalus03/workshop.html

http://www.airsoftretreat.com/reviews/showproduct.php?product=191&cat=49

I think this is a better guide personally. (more descriptive)

ok those are both a little bit confusing on how to get the barrel out

whoops sorry that was a hop up guide

http://www.airsoftforum.com/board/lofiversion/index.php/t43274.html

here you go